Kawasaki Z900RS

All BARRACUDA LICENSE PLATE HOLDER KITS, if installed correctly (see specifications below), comply with the current regulations of the Highway Code

For CORRECT INSTALLATION in accordance with the law, it is necessary to:

• Adjust the INCLINATION to a maximum of 30°
• TIGHTEN the joint well so that the inclination cannot be changed while driving voluntarily or even accidentally
• Install the BARRACUDA APPROVED LED LICENSE PLATE LIGHT
• Complete the installation with the REFLECTOR KIT
• Ensure maximum visibility of the rear view

The BARRACUDA LICENSE PLATE HOLDER are developed in a special carbon-loaded plastic with a STAINLESS steel joint, materials that guarantee lightness and strength at the same time.

WE DO NOT RECOMMEND installing additional plates to the X-TARGA to avoid weighting that could cause possible breakages. To obtain the license plate inclination, a STAINLESS STEEL joint is used which guarantees its movement and robustness (exclusive BARRACUDA technique).

Each kit is specifically designed for individual motorcycles, offering a complete assembly kit with everything needed. All BARRACUDA LICENSE PLATE KITS are complete with instructions and assembly kit and for installation, they DO NOT require any modification to the original parts of the motorcycle. It is important during installation to adjust the license plate inclination to the maximum limit of 30° established by the highway code and then fix and block the joint.

To complete the LICENSE PLATE KIT, we recommend purchasing related components such as the LICENSE PLATE LIGHT and the REFLECTOR. The assembly instructions are included in the original packaging, furthermore they can be downloaded in PDF file by clicking the link on this page.

For any further information or technical needs, please consult the Contacts section at the bottom of this page and write to the email address indicated.